Vanner RE Series Installationshandbuch PDF herunterladen (Seite 54)

RE Installation Manual

4-18



2001 Phone: (614) 771-2718 RE-4500

Vanner Inc. FAX: 614-771-4904 Owners Manual

4282 Reynolds Dr. www.vanner.com Rev 01e

Hilliard Ohio 43026 RE-Installation_Manual_Rev01e 910157-A

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

NOTE

It should be noted that the RE-4500 is shipped with the Factory

Settings for flooded-cell, lead acid type batteries.

Warning

Please refer to the manufacturers data sheets for setting up the

appropriate set points for voltage and current for your charging

system. Failure to do so could cause damage to your batteries and/or

reduction in their life. Wrong settings could also cause other damage

to the system and voiding of your manufacturer’s warranty.

Example 1 – 3 Step Charging Cycle

This section will assist you in setting up the charger. The

example shown below is for a 3-stage bulk charge sequence for

a flooded battery system. Please consult the Battery

manufacturer’s recommendation for any additional setpoints

and charging steps for your type of battery.

Go through the charger menu as shown in Figure 4-6 and

set "Charging Steps" to 3. Then hit the MENU key to go

into the charging steps menu.

Perform the first set of charging steps:

Set "Charge Step #" to 1. (The first charging step).

Press the Top Right Key.

For the time being, leave "Charge Stage ," the charge

step name, whatever it is, "STRT?" Again, Press the

Top Right Key.

Choose the "Charge Type" to be "DC CURRENT."

Press the Top Right Key.

Make the "Charge Setting" "0.0 Adc." Press the Top

Right Key.

Choose the "End Chrg Type" to be "<DC VOLTAGE.

" Press the Top Right Key.

Next set the "End Chrg Set'g" "22.00 Vdc" (

44 V

for

the RE48-4500

) or whatever voltage you want the

batteries to deplete to before charging. Press the Top

Right Key

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare

Vanner RE Series Installationshandbuch Seite 54

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Netzteile und Wechselrichter Vanner RE Series